FLOWCON - Automatic Flow Regulator

Water Flow Regulators

Accurate Control and Perfect Process Monitoring
Precise, stable mold temperature through automatic control
The development of this unit is based on many years of applied experience
Microprocessor controlled accuracy +/- 1C °
Up to 8 zones can be controlled individually
Storage of setup data for 7 different molds
A tolerance window can be set on the display. If the temperature exceeds the tolerance a buzzer or alarm contact is activated.
Serial interface for data transfer to IMM standard
Secures the quality of the molding process by perfect temperature control and monitoring
Plunger type solenoid valves with large seat diameter ensure operation even with poor water quality

Green LED shows that valve for the circuit is open RED LED shows that temperature is out of tolerance
Actual/Set temperature
Selection of set point, tolerance, slave control of circuits
Automatic or manual (fixed cycle) mode
Settings for slave controlled circuits
Selecting circuits

Close to the Cavity
Requirements for zone 1 - 8:
Mold sensor FeCo type J, Ø = 6 mm incl. M10 x 1
Cabel = 2000 mm
Order No. D900000542

Requirements for zone 1 - 8:
Water sensor FeCo type J, Ø = 1,5 mm, length = 100 mm
Cabel = 2000 mm
Order No. T700000855

(incl. screwfitting for the sensor, connection piece fittings
G 3/8" and reduction G 3/8" to 1/4")
Order No. D900000550